Make Wiring Worry-Free with a Digital Multimeter! Whether you’re a DIYer or a seasoned pro, installing electric radiant floor heat may seem a little intimidating. It doesn't have to be! A digital multimeter (or ohm meter) is an essential tool...
Read MoreCategory: Troubleshooting/FAQs
Can a thermostat heat two mats to different temperatures?
Mats attached to the same thermostat will heat to the same temperature. This is why it is recommended that every room have its own thermostat since every room has its own base temperature. It is also strongly recommended that areas...
Read MoreHow do I use Self-leveling Concrete with Radiant Floor Heat?
To apply self-leveling concrete before installing tile, simply mix the powder with the amount of water specified in the instructions, cover any holes in the floor such as vents or toilet rings, and pour the mixture over the subfloor until...
Read MoreWhat objects can I put on top of my warmed tile?
WarmWire cannot be installed below built-ins, cabinets or walls. However, rugs, hampers, scales and waste cans are OK when your finished floor is stone or ceramic. The area under the rug or other objects will get warmer, but will not...
Read MoreWhat is the typical operating temperature range for a WarmWire floor?
Radiant floors should not exceed 85 degrees F at the surface. 85 degrees is our skin temperature, so anything warmer starts too feel too warm. Floor coverings other than stone or tile REQUIRE a maximum temperature below 85 F. Most...
Read MoreWhat is the recommended procedure to apply thinset over the floor heating wire?
Start with a good quality latex-modified thinset. Use the flat edge of a notched trowel to push the thinset over and into the wire. Then reverse the trowel and use the “comb” side to rake the mortar over the wire...
Read More